
Emergency starter power supply and air pump all-in-one machine
Designed with multiple emergency functions in mind

20-Cylinder Compressor More Powerful
- Precise digital display
- USB power sharing
- 8000mAh new super-large battery
- Five working modes
- high-brightness lighting

Ultra-Low Temperature Resistance Minimum -40°C
Strong low temperature resistance allows users to use it normally in extremely cold environments

Integrated Perforated Heat Dissipation
Integrated mold heat dissipation holes reduce the engine operating temperature Increase the engine life
Smart Safety Chip 12-level Comprehensive Safety Monitoring
- High voltage protection
- Low voltage protection
- High temperature protection
- Low temperature protection
- Overcharge protection
- Over discharge protection
- Overcurrent protection
- Short circuit protection
- Power failure protection
- Reverse connection protection
- Reverse charge protection
- Shockproof protection

20 Cylinder size compression is more efficient
Large cylinder can compress more gas at the same power Bringing a very objective efficiency improvement

Automatically stops when fully chargedIntelligent control makes it easier to use

12V diesel/gasoline new energy general purpose
- sedan
- motorcycle
- off-road vehicle
- van
- SUV
- electric vehicle
- commercial vehicle
- pickup truck


10AWG Specification Ultra-thick low-resistance cable
Lower resistance is effectively reduced during use wire heating greatly increases wire life

55W Large Motor More powerful

USB Shared Power Super Power Bank
- Tablet
- iPhone
- Android phone
- Digital camera
- Mobile power bank

8000mAh battery Ultra-large capacity for worry-free battery life
Large battery not only provides longer battery life.It also has a longer cycle life under the same working conditions
Explosion-proof and high temperature resistant
Using heat-resistant and environmentally friendly plastic.Sturdy and does not deform in high temperature environment

Correct Installation Usage Steps
Step 1: Connect the positive and negative poles of the car
Clamp the positive pole of the car with the red clip
Clamp the negative pole of the car with the black clip
Do not connect the positive and negative poles in reverse to short-circuit
Make sure the contact area of the metal teeth of the clip is as large as possible
Step 2: Connect the starting power supply
Plug the clip power supply and the starting power supply
Interfaces must be fully inserted to the bottom
No need to light up the screen, the starting interface is always powered
Step 3: Complete the ignition operation
Get in the car and complete the ignition operation within 30 seconds after connection
Do not start the car that is difficult to ignite continuously
No need to light up the screen, the starting interface is always powered
